|
U-POL David's Isopon P38 Bodyfiller P38 polyester filler is a two component chemical paste (filler and hardener) used for filling holes and imperfections in surfaces such as steel and GRP. P38 has been specially formulated for the professional user and the DIY hobbyist. P38 combines good filling and smooth spreading properties together with easy sanding finish. P38 can be used on the following surfaces, bare steel, degrease and abrade with P80 paper, original paint surfaces (with the exception of thermoplastic acrylics) degrease and abrade with P180 grit paper and GRP degrease and abrade with P80 grit paper. P38 can be over-painted with most types of paint including 2K. Ideally a primer is recommended prior to painting. P38 is very easy sanding which makes this product easy to work with. P38 also has good good filling properties enabling this product to be multi use. Trade Dicounts Available |
U-POL David's Isopon P38
Mixing ratio: 100parts filler to 2parts hardener
Pot life: 4-5minutes once mixed with hardener at 20°c
Sandable after: 15-20 minutes 20°c
U-POL David's Isopon P38 Bodyfiller Can be used on pretty much any surface of a vehicle from bare metal to Glass fibre panels.
Prepare the surface by removing any rust, dirt or grease.
Next using sand paper or a DA sander rough up the area to add a key to help the filler adhere.
This is a 2 component filler. Mix 100parts filler to 2parts hardener (Golf Ball of filler to a Pea of hardener)
Once mixed you have a round 4-5minutes to apply the filler before it starts to set.
Try apply the filler as smooth as you can as the will save time when sanding.
If the dent or hole is quite deep you may need to apply 2 or even 3 coats to build up the layers.
Within 15-20 minutes the filler will be dry enough to sand.
For best results do not use anything less then an 80grit for shaping and smoothing the filler
Goggles and a dust mask must be used. Data sheets are available on request.